Tel: 0086-771-6306699
Fax: 0086-771-6306688
Website: www.zmjx6688.net
Website:en.zmjx6688.com
E-mail: gxzmjx2008@aliyun.com
Add: No. 19, Yongxing Road, Guangxi-ASEAN Economic & Technological Development Zone
working principle:
The general materials are preheated by the centrifugal pump pumped into the cold hot material heat exchange device in the sterilizer, then passed through the high temperature barrel filled with high pressure, the materials are quickly heated to the sterilization temperature maintained for about 3 seconds before after. enzymes were quickly killed.
After the material comes out of the high temperature barrel, it is cooled by heat exchange with the cold material. The general temperature is lower than 65 ° C.
If the next process needs to increase the temperature, it can be achieved by adjusting the angle-type shut-off valve circulation, otherwise the cooling temperature is reduced to reduce the discharge temperature. The discharge is controlled by a throttle valve, which can make the boiling point of the material higher than the high temperature of zui under a certain pressure.
This valve is adjusted during normal production, the back pressure control flow is generated by the pump's driving force to overcome the spring pressure. When the sterilizer is cleaned, it should be fully opened. The circulating storage tank can be used to prepare acid alkali solutions to effectively clean the inner wall of the coil. Due to the simultaneous use of stainless steel three-way cocks, the flow can be appropriately adjusted.
Pharmaceutical machinery manufacturer, features:
1. Continuous production, extremely short sterilization time.
2. High quality products can be obtained due to short heating time.
3. As the ultra-high temperature sterilization is adopted, the sterilization effect is particularly good.
4. It is used in series with a centrifugal pump a high-pressure homogenizer. It has a wide range of applications is suitable for sterilization of high-viscosity materials.
5. Because the heat exchanger with hot cold materials is designed to have the economic effect of waste heat utilization, the steam consumption is small.