How to use maintain automatic filling machine

The automatic filling machine adopts a touch-type man-machine surface. As long as you follow the instructions on the display screen, you can easily go online without any experience, greatly reducing the training time, you can set the production speed arbitrarily,  you can automatically adjust the production speed. Speed of any production line for efficient production operations.

Use  operation method of automatic filling machine for pharmaceutical machinery manufacturers:

1. Before the automatic filling machine is turned on, check the disinfection liquid level; whether the power supply  air pressure are normal; manually check whether the solenoid valves  cylinders are good; whether the actions are normal; whether the water pumps are turning correctly; Endless. If abnormal conditions are found, the fault can be eliminated before production.

2. The automatic filling machine automatically performs flushing, disinfection, filling, capping  capping during production, without human interference, but the operator must closely observe the status of each part, find problems,  automatically turn to the manual in time to prevent accidents The accident happened. When the position of the chain is  correct, push the spindle manually,  then push the chain to the normal position. The disinfectant should be replenished in time to prevent the pump  idling under dry conditions  burning out the seal.

3. After the production of the automatic filling machine is finished, the residual liquid in the pipeline should be discharged, the gas path  water source should be cut off,  the power supply should be turned off.

Daily maintenance methods of automatic filling machines for food machinery manufacturers:

1. We must inspect some parts regularly  inspect them regularly. The inspection parts are: worm gears, worms, bolts on the lubricating block, bearings  other moving parts, to see if these parts are flexible  worn,  defects should be repaired in time  should  be used barely.

2. The automatic filling machine should be used in a dry  clean room. Try  to use it in places  the atmosphere contains acids  other corrosive gases.

3. After the automatic filling machine is used, it should be cleaned  then installed properly to prepare for the next use.

4. If the roller moves back  forth during work, please adjust the screw on the front bearing to the proper position. If the gear shaft moves, please adjust the screws behind the bearing frame to the proper position, adjust the gap so that the bearing does  sound,  the hand-turned belt pulley is properly tightened. Too tight  too loose can damage the machine.

5. If the packaging machine equipment is  used for a long time, the entire body of the automatic filling machine must be cleaned,  the smooth surface of the machine parts should be coated with anti-rust oil  covered with a cloth awning. If the device has  been used for a long time, you must check whether each part is normal before using it.